Advertisement
The PM Model incorporates a rotor/stator configuration that promotes dual flow through a special Delta rotor/stator. The higher flow promoted by this design is suitable for agglomerate reduction and the production of fine emulsions. When the product requires multiple passes in a media mill, experience has shown that the unit can reduce milling time by up to 50 percent. Cycle times of 15 to 30 minutes are typical. Several models are available from 5 through 200 hp.

Charles Ross & Son, Hauppauge, NY; 800-243-7677; www.mixers.com

Editor's Note: When a media mill is used to finish a product in a single pass, the PM Model can most often eliminate the need for the mill altogether.

Advertisement
Advertisement