Choosing the Right Pump for Coal Preparation
As much as 50 percent of the material that comes out the ground during coal mining is waste: dirt, rocks and other impurities that must be removed from the coal before it can be processed and burned. Coal is washed, crushed and sized at a coal preparation plant, where throughput can average 4,000 tons an hour. If process and wastewater streams are not well-managed, a coal prep plant can flood, become dangerous to work in or be forced to shut down. There are several locations at a coal prep plant where pumps are required to handle collected water: in holding ponds fed by runoff from raw and clean coal stockpiles; in basement cleanup and conveyor belthead sumps; and in truck-washdown sumps. In most cases, the water to be pumped is a muddy, abrasive slurry laden with coal fines, briquettes, dirt and even nuts and bolts from broken machinery.
A recent shutdown at a coal prep plant in eastern Kentucky was caused by the failure of a self-priming centrifugal pump in the main floor cleanup sump. The pump’s suction attracted solids at the intake, but because the pump’s hydraulics were inadequate to pull in heavy solids, the pump only dewatered the sump and left the settled coal and plant waste in the bottom of the sump. Eventually the self-priming pump’s hose was choked by the buildup of solids; the pump starved and failed. The only way to remove the solids from the sump was to manually dig them out with a shovel.
The plant replaced the self-priming centrifugal pump with a 15-horsepower, high-head KZN110H pump from BJM Pumps. The KZN is an extremely durable, top-discharge pump with a mechanical agitator and wide clearances. Because it has a straight path from intake to discharge, the KZN uses the pumped liquid to cool the motor, and because it does not have an elbow joint like a side-discharge pump, it has fewer surfaces that can wear and potentially fail. In fact, the KZN110H at the eastern Kentucky coal prep plant has run problem-free for more than a year, and the cleanup sump is consistently free of process debris. The KZN’s agitator has kept particles suspended in the slurry while large, 1 3/8-inch holes in the strainer have allowed virtually all of the solids to pass through. Because the pumping components of the KZN — notably the agitator, impeller and wear plate — are constructed with abrasive-resistant, high-chrome iron, the pump has been a workhorse and has completely dewatered the sump.
For more information, please visit www.bjmpumps.com.