Booth 1328 This continuous gravimetric extrusion control software package offers the ability to control the extruder speed so that its output has a predictable and repeatable mass flow.
Booth 5316 The Ox heavy-duty drawer-in-housing unit incorporates design elements that are essential for optimum magnetic separation performance in challenging processing conditions.
Booth 2531 These custom-engineered shaft seals for rotating dry bulk process equipment provide an alternative to packed gland-type seals in clean-in-place systems. The shaft speed envelope now extends to 1,000 surface-feet-per minute on dry-running shafts.
Booth 1000 A recent increase in capacity required an additional L-size Turbo-Dryer to heat-treat a fine (70 micron) metal oxide powder. This design can operate at temperatures up to 650°C to calcine or sinter metal powders.
Booth 1945 The K-S paddle dryer allows drying to moistures of 0.5 to 0.1 percent with a continuous process, providing uniform heating and residence time.
Booth 2143 Developed in collaboration with FGR Automation & Controls, this fully automated train batch weighing and loading system has been successfully implemented on a variety of materials including coal and coke.
Booth 2231 The PistonFire explosion suppressor is a dry chemical suppressor that is designed to meet the new stringent requirements of NFPA 69 (Standard on Explosion Prevention Systems).
Booth 1005 This bulk bag conditioner-unloader system loosens bulk solid material that has solidified during storage and shipment, allowing the material to discharge through a bag spout.
Booth 1937 The APEX Screener features an ergonomic design and increases uptime by allowing quick screen changes, while retaining the same process efficiency and gyratory-reciprocating motion of the Rotex Screener.
Interphex 2008, a leading conference that covers the spectrum of life sciences, will run March 26-28 at the Pennsylvania Convention Center in Philadelphia. Billed as a trusted source for leading-edge technology, education, and sourcing of the products
These direct drive, vertically mounted process plunger pumps are designed for continuous operation. The wetted components are manufactured from rust- and acid-resistant materials. Because the pump is mounted vertically, the cross head and plunger weights are neutralized within the sealing system
The 787F side-exit, low-profile accelerometer is the integral cable version of the 787A side-exit general-purpose sensor with a permanent Viton boot and Teflon-jacketed cable to provide protection in harsh environments
An oil sight glass can be installed on pumps, gearboxes, bearing housings, and other lubrication-critical pieces of equipment to make possible the constant monitoring of bearing oil and the observation of contamination with dirt, grit, and water
These single-row angular contact ball bearings feature high radial and axial load capacity, high speed capabilities, and a steep contact angle of 40 degrees to meet the requirements of centrifugal pumps. The bearings are engineered for universal mounting in multiple arrangements including face-to-face, back-to-back, and tandem
PoxyBlock motor and pump mounting block kits are engineered to outperform steel blocks on any baseplate. Designed to be an economical alternative, they promise unmatched parallel tolerance and surface flatness as well as the excellent corrosion resistance of Zanite